Search the Community
Showing results for tags 'rsd-12'.
Found 2 results
Murdoch17 posted a topic in LEGO Train TechThis model was originally a ALCO MRS-1 built by Anthony Sava, but has been so severely modified that it no longer looks like the prototype loco. So I went searching And found another ALCO locomotive, a RSD-12 that looks like my loco. Both my model and the prototype have the six wheels, and the same basic hood and cab design, plus the curved ends match the RSD-12 better than the sharp-ended MRS-1. ..and here is my Lego model of it, as Brick Railway Systems loco number 7924. I even thought about putting two of this part under the headlights at both ends, but I think the model looks better the way it is now. NOTE: The printed letter tiles with the railroad's initials "BRS" will go on the long hood. I misplaced the two letter "R" tiles, and need to order some more, but the rest of the letters are on my desk. (They are hard to keep from rotating without the middle letters to hold the others in place, so they are not on the model yet.) The center axles on these six-wheel bogies slide left and right to allow for tight turns on switches and flex-track. I took Anthony Sava's original design and beefed it up, making it a lot stronger and a little taller. Here is the picture (not mine) I found that matched my model. I also believe this is the last ALCO RSD-12 left. (I could be wrong, though.) The photo is originally from here. Here is the LDD file for the diesel loco as shown above. Comments, Questions, Suggestions, and Complaints are always welcome!
Murdoch17 posted a topic in LEGO Train Tech"I've been working on the railroad, all the live-long day!" This train consists of a ALCO diesel locomotive (specifically a RSD-12 type) and four cars: - a (working!) crane car - depressed-center rail wagon - a (working!) ballast hopper - caboose The model features several neat printed pieces found in several Juniors sets and six mini figures, including four generic track workers, one track boss / conductor and the locomotive engineer. This model was originally a ALCO MRS-1 built by Anthony Sava, but has been so severely modified that it no longer looks like the prototype loco. So I went searching And found another ALCO locomotive, a RSD-12 that looks like my loco. Both my model and the prototype have the six wheels, and the same basic hood and cab design. The long hood of the loco has been designated the rear with a double red light. This stream crane model was heavily inspired by Whoward69's instructions for a set of crane and match truck train cars. I modified the original model seen here. I originally meant for the crane to have ropes to move the boom, but it got confusing on which rope went where so for now it's moved by the H.O.G. (Hand Of God) method. The crane can spin around in 360 degrees and lift anywhere up to 90 degrees straight up. (Their is a double set of pins keeping the boom from going too low, as well.) Here we see how the crane is hooked up to the depressed center flatcar most of the time. The heavy-duty depressed-center wagon has brick-built arms to secure the cargo of railroad track in place. This model was inspired by a coal hopper on an older website called LGauge .com. I tunrned the old finger hinges into new pin-orientated ones and colored the car yellow to match the MOW paint scheme. The hopper's bottom door open and can dump 1 x 1 round plates / bricks onto the tracks for ballast. The caboose features two ladders (one per side) and more of those fancy printed 2 x 4 tiles. The mini-figures seen above are stationed on the MOW train. As usual, Comments, Questions and Complaints are always welcome!!