Jump to content

Balrog

Eurobricks Counts
 View Profile  See their activity

  • Posts

    988

  • Joined

  • Last visited

 Content Type 

Everything posted by Balrog

  1. Balrog
    That's sick. I wonder if it wouldn't be better to build outriggers to somehow operate from the upper structure instead.
  2. Balrog
    I'll take it for 50
  3. Balrog
    Congratulations everyone!!!
  4. Balrog
    The fenders in the rear are better.
  5. Balrog
    Probably tomorrow, if I don't forget it ;)
  6. Balrog
    Also, the visible structure is a little different in each case.
  7. Balrog
    There are pinholes on the left and right side just as on the 5x11 rectangular panels oder the 3x11 panels. There you could use a 5L and a 3L beam to secure the panels together.
  8. Balrog
    The panel seems to be the same on the left and right side. But I think the question was, if you can put one of those panels upside down on another one and make "one big panel" with 8x11. From what I see, this should be possible, because the angled section starts at the middle of the pinhole on both sides.
  9. Balrog
    Definately two(!) per wheel
  10. Balrog
    I like it so far. The only thing that seems a bit off is the roof railing. I think it should be only 2 studs high instead of 3, so there is only a 1 stud gap between roof and rail. But that's just my opinion.
  11. Balrog
    Category A # 6 # 11 # 7 Category B # 3 # 6 # 10
  12. Balrog
    That will be permanently in use by efferman
  13. Balrog
    Seems more like 16L to me, but nicely spotted.
  14. Balrog
    Zblj this is a real classic. I love how it disassembles itself upon contact with obstacles But I think you built it to good to tip over when making sharp turns
  15. Balrog
    I am not sure about 42039 anymore. I liked the preliminary version somewhat better. Now doubt, this still makes a good parts pack, but the design is not as sleek anymore. Also, could it be that 42037 has new wishbone parts?
  16. Balrog
    Well, I disassembled Sheepo's Mustang recently. It took approximately 4h of pure disassembly. Then another few hours sorting all the stuff back into my storage.
  17. Balrog
    Page 12 at the bottom for example ;)
  18. Balrog
    That is 9395! At 0:29? That is 9395!
  19. Balrog
    The PF Servo Motor automatically returns to the center. Afaik it will only stay in position if you use the speed controller. With the normal PF remote a neutral position on the controller automatically centers the Servo.
  20. Balrog
    So the whole second stage stays in that last segment. Still, I can only think of reinforcing the upper side of the boom along its length. At least at the front two panel segments.
  21. Balrog
    8880, 8448 (afaik), 8466 ... these come to my mind instantly. I am not sure if there are any more.
  22. Balrog
    How many studs does the second stage remain in the first stage?
  23. Balrog
    I don't see the longitudal reinforcement. Can you post a picture from above?
  24. Balrog
    On the first section you should make longitudal reinforcements. E.g. Connect the curved panels on the upper end with beams. Should help a bit.
  25. Balrog
    Please document the unboxing and so on
×
×
  • Create New...