Zerobricks

Seems that the engine uses the small engine cam, but is somehow connected to the large cylinders.. Very unusual.

Looks good, but why are you using CV joints on the rear fixed axle? Seems like a weak point.

Just noticed, there is a concave 5x5 panel under the fuel tank.

Yes, the two sides. I think the suspension arm has a + O ∩ shape. Since the 9L link no longer require tops to keep the from falling out, they may have been redesigned to be without stoppers like 6L.

Nah, seems just like 2 levers with 2L axles instead of one.

Seems the suspension arms are built from a 3L suspension arm which has a + crosshole plus two diagonals.

I sure hope not and that it's just an aesthetic update to the engine block module.

Nice to see a gearbox, finally something new. Also I wonder if the new engine blocks are just simply a new look, or a totoal redesign.

No, those are way too small.

Here are the new parts I found: 2L beam with a ball joint New wishbones 2x5 Micro panels New, longer links?

Everything is available at the support page: https://buwizz.com/sl/support/ https://buwizz.com/contact-support/

I think it would be too fragile.

Usually holes are around 0,2 mm too small when printing stuff, for which you can compensate in the 3D model or the slicer.

Well done. May I ask what's the advantage of having the front axle geared up compared to the rear? Regarding the question of L motor housings, that was the original idea, but the motors are too enclosed for proper cooling and can't be stacked easily.

I'm not totally sure, can you send a support ticket and I will FWD it to the app dev? Thanks

I would extend it by an extra stud to make it stiffer so you don't rely just on the crosshole connection.

Just look at sets like 42114, 42145, 42009, 8258, 42082, etc...

Thank you. I am THE support person for technical issues... I found the command: 0xA1 Activate shelf mode Activate the shelf mode in the device immediately. This will disconnect the battery from the device and will require the user to connect the charger in order to wake-up the device. Byte Function / value 0 (command) 0xA1 – Shelf mode Try sending it via nRF Connect. I will remind the app dev to add this to the app.

There should be a command in the API, but currently I'm unable to check which exactly, since I'm recovering from surgery...

How about fusing the 24 tooth gear and the hub bearing into a single part to reduce complexity.

It has to, since PF Servo is powered by the outer cables.

You can use the new, shorter clutch rings from Yamaha which allow the 16 tooth gears to pass near them and avoid the use of weak 8 tooth gears.

It's on all pins.

Softer material is being used for the past few years which means parts have to be redesigned. I'm not sure, but I think they switched from ABS to MABS which can be moulded in transparent colors without needing a seperate mould.

Use piece 2393 as a hub.