Zerobricks

So, any info on how powerfull the L and Servo motors are?

Hehe, like I said few posts back... Too bad they cant be used to hold the gears inside the portal hub.

Stolen from german forum

BTW how are the L motors? Any difference compared to M?

No it makes sence, the remote in crawler stops sending signal when not steering hence servo goes in center... it acts as a motor but with limited angle, thats all!

Doesnt it steer to center when there is no signal as you press the stop button on train remote?

There are bricks holding the outside of the 12 toothg gear! The axles's fat part is inside the frame. The 12 tooth gears is behind the fat part. The axle cannot slide out of the 12 tooth gears cause ofits fat parts and the gear cant slide cause there are bricks holding it.

Think! The ring on axle doesnt allow the gear to slide of. Because the gear cant slide out the whole axle cant slide out of the diff. Its so simple, you just have to get it

He's been smilling for the last 2 years! Finish'er up!

Electronics? A simple optical or mechanical switch.

I think it keeps the axle from sliding out of the differentials? And also from sliding out of motor holes?

I dont understand the point of the new axle... I thought it will be something like a 4L axle with a stop? Unless the round part keeps the gear from falling off/sliding out the axle... oooh got it...!

Servos arent fast... RC motors, flat 9V motor?

Very good astehitcs, especially the angle connector made fenders! And it drives too

Thanks for replys guys. the reason I did not use the new unimog pumps, because they are too expensive and i use what i have. I dont quite understand the deal with colors, as real tractors also have the green/white combo.

Here's my new MOC. I wanted to re-use the big green wheels but in less trial-truckish kind of a way. The tractor has: Pendular front axle Working front and rear PTO working pump working 4x4 drive working steering wheels gearbox to control the functions fake I4 engine It also comes with a digging arm attachment which has: working rotation and workings of the arm outriggers powered by rear PTO The arm can fold nicely: The front PTO is excentric dueo to the position of the engine. Underside showing the mess of gears and the pump (at least some 50 gears were used) Tiltable front axle: Each wheels also has a 1:3 reduction gear ratio inside the hub: And the video:

Simple and it must be fun to drive!

Wow, that is really massive! The pump sure gets a hammering from the RC motor!

No, WD-40 melts plastic!

Silicon spray

Looks really massive, but the wheels look a bit undersized in front.

Lol, how she slaps it Animals can be so crazy and cute

A big tractor with pneumatics, 4x4 and compressor

My first technic set too! And my mother and sisters built it, cause they thouht i was too young

I think the set is from time, when designers were experimented with futuristic models, like the year before with the blue tow truck, bike and the racing car. I actually like its looks and double front axles and the use of slizer parts.