Search the Community
Showing results for tags 'flipper'.
Found 3 results
Did you play Pinball when you were young? If you're as old as I'm, I'm sure you do. My Lego Pinbal is very simple. The board is built of bricks and reinforced with technic liftarms so it is very strong. You can fix it to the table with two actuators so that he would not move while playing. If you like it you can support this project on Lego Ideas - https://goo.gl/vxRv39
As promised (I know I'm a bit late ) my new project! Recyclopse from robot wars it was a big roundish bot with an exendible tongue that has a flipper hided into it, Made with recyled materials: recycl-opse As usual i start building from the aesthetics, because i have few pieces to make that green shield, this is the shield with the tongue and a try to put electronics inside I used dark green bricks (the only i have) that has the same color of the real one but the result is a piramidal shape, fit everything in will be an hard challenge I thought about three options: -one RC motor (pump+valve) for the flipper, L/M motor for tongue extension -one M motor for the flipper; one L motor for tongue extension -one XL motor for tongue extension, at the end of the travel two strings linked to the chassis will act the flipper (M motors are for the wheels, trough chains) hope I can make sole tries asap, last hope is to make a 2 section angulation for the shield (=more space) but this means gray shield or maybe with mixed pieces... receivers will replace that green transparent brick
hi! this isn't my newer MOC and due to have posted some photo into facebook it can't be an entry for the TC6, anyway jim suggested me to start a topic and there is! FEATURES: -L motors for tracks drive, they are covered due to protect the tracks and to use the space inside them -XL motor to power the winch, it is needed to reload the flipper :3 -old squared motor for the winch control, you can disconnect the winch from the XL motor trough a little gearbox to release its power instantly -2-times-twisted-green-rubber-band-powered (muhuhahahah) flipper -simple 4 channel remote control -LiPo battery box designed with the lowest ground clearance and with covered tracks to make it unflippable and resistant to spikes, however its flipper can work as a srimech unfortunately I have only this picture but tomorrow birckshel should opent its file and I'll link there, and also the lfx file :3 also I have some videos in the facebook group called "lego robot wars (LRW)" it could be perfect for sbrick because it allows to make battles between more than two robots, and also the electronic works better with the 2 L motors that sometimes stops this is a link to a short video on Facebook in the LRW's group hope is possible to see it https://www.facebook...727476340692630