Hello all,
I present you my skycrane made for the 29th Techlug contest
I tried to make a simple and playable moc
the competition is based on a moc manual that must be powered by a M motor and a technic BB.
the cabin is largely glazed permetre for pilots to see outside:
In the center are the gearbox, winch, both engines (dummy: D) and the rotor. A landing gear with suspension occurs from each side.
At the rear the tail and the tail rotor.
At the clip, I looked for a system that allows a quick setting of the container and above a simple and quick release. The principle is a clamps formed of two Liftarm 2 x 4 L-Shape connected by a Axle Connector (Smooth with x Hole + Orientation) that are kept closed by an elastic.
The hook formed by a Axle 3 with stud enters the system by removing the clamp and gets stuck. Then slightly lift the container.
To release, simply remove the clip by both Liftarm 1 x 2 Thin. Simple but effective
it is possible to raise the helicopter by the tail or even by the cab
Placing the engine: under the roof of the cab, it is guided through an opening of 3x3
The BB
result:
And a short vidéo:
Thanks for reading me ;)