Sicil Posted November 10, 2012 Hello. I want to introduce you to model of dump truck/ I was thinking about what to make a long time, but in the end I decided to build dumper. The model was designed fully controllable, but unfortunately due to the lack of a linear actuator had to tinker with the control function of raising and lowering the body, which ultimately affects the very rapid and abrupt management body. Model was created for a long time - about a month. All planned, that I have in this model be realized. PF-equipped model: XL-motor to drive M-motor for steering M-motor raises / lowers the body To begin viewing stuffing of model. I also managed to implement oscillating axle. Device management of body Several additional photos. And finally a video showing features of the model. That's all. Thank you for your attention. Your Sicil . Share this post Link to post Share on other sites
legomuppet9 Posted November 10, 2012 This works well and you have got me thinking about what I can build next after my current project... Share this post Link to post Share on other sites
Zerobricks Posted November 10, 2012 SMall and cute! But reinforce the middle, because ite bends pretty bad. Share this post Link to post Share on other sites
Sicil Posted November 10, 2012 This works well and you have got me thinking about what I can build next after my current project... Thank's. I'm glad that I gave you the idea. SMall and cute! But reinforce the middle, because ite bends pretty bad. Unfortunately I was not able solve this problem. Share this post Link to post Share on other sites
Alasdair Ryan Posted November 10, 2012 Small but good. I am not a fan of the middle joint like Zbij says its a bit weak. Share this post Link to post Share on other sites
hrontos Posted November 10, 2012 I like the compact size. Very nice. That turntable is really a weak point, but reinforcement would probably mean to make it larger. And I like the current size. Just right for kids to play with. Share this post Link to post Share on other sites
Alasdair Ryan Posted November 10, 2012 Ta Da....... Download LXF File. Share this post Link to post Share on other sites
Tadej Posted November 10, 2012 A lot of PF on such a small model, good job. But you should really reinforce the joint, lego usually uses two connection points on their articulated vehicles - upper and lower 1 stud apart like on 8465. Share this post Link to post Share on other sites
Sicil Posted November 10, 2012 (edited) Thanks for your comments/ Ta Da....... Download LXF File. Alasdair Ryan. Your idea is very good but unfortunately there isn't find a place for propeller shaft and it's large enough for this model. Edited November 10, 2012 by Sicil Share this post Link to post Share on other sites