legosamsonite Posted February 5, 2016 (edited) Hello. I got a 1x1 brick with holes on all sides. I put a lightsaber blade through it and now it's stuck. Is there an easy way to remove it? Im worried i will break it Thanks Edited February 5, 2016 by legosamsonite Share this post Link to post Share on other sites
MAB Posted February 5, 2016 Grab a piece of foam rubber or even a tea towel, use this inside the jaws of pliers to pull the bar out. The soft material will protect the parts from damage, but allow a grip on it still. Share this post Link to post Share on other sites
ejred Posted February 5, 2016 I concur--I put a bit of rag (cut up athletic sock) on it, and then pull with needlenose pliers. Works every time and no damage Share this post Link to post Share on other sites
legosamsonite Posted February 5, 2016 (edited) Like it is stuck in both pegs? That will work? It is very friction tight Edited February 5, 2016 by legosamsonite Share this post Link to post Share on other sites
dr_spock Posted February 6, 2016 You can try to push it out as far as it can go by pushing the brick down on the light sabre blade. That should give you more length of blade to grab and less blade to pull out of the two holes. Share this post Link to post Share on other sites
Bryboy747 Posted February 6, 2016 Here is a diagram for your convenience. Share this post Link to post Share on other sites
legosamsonite Posted February 6, 2016 I got it fixed. Thanks everyone Share this post Link to post Share on other sites