Redimus Posted November 5, 2015 (edited) I've recently picked up the 12v controller and a signal set, and intend to pick up some lamps too. I really like both the look and the way they are controlled. I also love the way it's all controlled from one central control unit. So here's my question: Has anybody either modified the innards of the 12v controller to drive 9v or modified 12v motors and controller to rail wires to run without the central rails? I'm keeping my mind pretty open at the moment, just looking for ideas that (with the minimum of modifying aging mechanisms) that would allow me to use any part of the 12v system on a more modernly powered layout. Worst case scenario, I'll just use the controller as a signalbox and nothing more, it's still pretty cool. :) Edited November 5, 2015 by Redimus Share this post Link to post Share on other sites
Heppeng Posted November 5, 2015 No modification required. Just don't turn the dial beyond 3/4 full power. Share this post Link to post Share on other sites
Redimus Posted November 5, 2015 It's that simple? Cool. Share this post Link to post Share on other sites
proshare Posted November 7, 2015 (edited) No modification required. Just don't turn the dial beyond 3/4 full power. Edited November 7, 2015 by proshare Share this post Link to post Share on other sites