efferman

thanks ok, this is really the last part: the fender for 8110 tires 8110 fender von efferman auf Flickr available on shapeways

Thank you very much

for unimog wheels it would be really expensive. a single mudguard piece for the 62,4x20 tires costs actually 3,14€ in white strong and flexible the next part which i make is an end part for this mudguard, and then i going in medical rehabilitation for a minimum of three weeks. maybe i have internet, but no access to inventor. edit: the endpart. 3 studs wide, 2 studs long with a rounded end

these are for 8110 tires, this look is on a 62,4x20 rim only possible if there is only a crosshole in the center and no pinholes around. to the mudguards, the first version is indeed to large in diameter. best looking is the left which has 10 studs from pinhole to pinhole, the middle has 11 and the right 12 studs. but has the smallest one enough space for steering? kotflügel test von efferman auf Flickr

thanks guys i have made a 3 wide version for single wheel and a tire for my 62,4x20 rims. it seems i have to reduce the diameter of the mudguard Baugruppe1 von efferman auf Flickr

and for the same tires i have made a mudguard piece. actually 4 studs wide. 8 of them would give a full circle with an outer diameter of 13 studs, but the most use would be this more mounting points? wider or more narrow?

The rims of post 297 http://www.eurobricks.com/forum/index.php?showtopic=91294&st=275#entry1843701 are for the 62x 20 tires

Thank you very much, yours looking good too

I think cad programs are like tetris. Easy to understand, hard to master. I have the inventor now for 4 months, and no teacher, so i think i have many things to learn.

How complex is it to use?

Milan, this tow truck is really strange.

Looks good, which program are you using?

My thought was a 5 long panel, then a bridge part, and again a 5 long. This would give enough flexibility.

simple solution

the studs are hollow, only the 3x1 has full studs useful part?

i dont have ordered this colours, so i dont know how good they match. edit, how about a panel like the curved 3x2x11 panels but in 5x3x5 ?

the part is uploaded panel corner

so sweet, i love it

snipe, the version i have uploaded is the only possible. dafgek, the one for 62x20 tires which are posted on page 12 doesnt work? a part for bodywork. a corner for round panels. interested for upload or any changes? ecke stoßstange von efferman auf Flickr

reduced to a minimum it makes 21 cents difference. funny, now you say the stud shuold between two holes, at last time under the holes. snipego 4x1 lowweigth von efferman auf Flickr this happens when the stud is under the hole complikation von efferman auf Flickr

have you a link to how this works?

it would be a few cents cheaper, but the studholes at the bottom sides need the material around them. too less material thickness is not good to print

thanks for this info! after all of these big rims, now one for the 62x20 rims. more offset and a clean inner side 62x20 rim von efferman auf Flickr

you need this or this to connect a micromotor onto a pf extension cable

snipe, filling the holes in the studs is no problem, but putting the clutches under the pin holes without blocking the pinhole is not possible drJB, these parts are already existing? edit: superleggera V2 is available edit² dion, here is the bracket to couple 2 small cylinders