edge_nl Posted December 2, 2018 (edited) Since my son is about 1.5 years old now, I have a very good reason to start playing with LEGO(/Duplo) again. :) Okay, we are still in the Duplo-phase (can't wait for mindstorms/robotics), we like to play with some custom cars. So this is a remix of a Citröen 2CV. The idea is using an existing 2x4 car base (like 12591c02) in such a way, minifigs are placed upon this car base. This will ensure a good LEGO connection, without too much printing tolerances issue's. In this case, you may notice a 3d printed car base. Although in general, from quality/price perspective I would recommend to buy standard LEGO/Duplo parts when ever possible. ps1: If you like more LEGO - 3d print combinations, we are happy to show more :) ps2. @MODs: Since I don't known, where to place this 3d printed MOC, feel free to move it somewhere else. ps3. When printed at 50%, it does NOT fit LEGO. (Duplo wheel axis are blow studs, while LEGO wheel axis are in between studs.) Edited December 3, 2018 by edge_nl Share this post Link to post Share on other sites