aeh5040 Posted October 16, 2016 (edited) Here is a little MOC for your enjoyment. It is a sphere (more precisely, a spherical icosidodecahedron), made entirely from one part, the trans 1x2 plate (1950 of them). It was very hard to put together, but it is very sturdy! Edited October 16, 2016 by aeh5040 Share this post Link to post Share on other sites
JGW3000 Posted October 17, 2016 I'm just flabbergasted. How much time did this take, all of those plates, didn't you go a bit crazy towards the end? Really well done, and I like that it is sturdy as well. Share this post Link to post Share on other sites
Gonkius Posted October 17, 2016 Amazing build! I will definitely build one myself. Share this post Link to post Share on other sites
Rotundus Posted October 17, 2016 Good engineering, nice build! Share this post Link to post Share on other sites
J_C Posted October 17, 2016 Your patience is something else. Amazing. Share this post Link to post Share on other sites
aeh5040 Posted October 17, 2016 17 hours ago, JGW3000 said: I'm just flabbergasted. How much time did this take, all of those plates, didn't you go a bit crazy towards the end? Really well done, and I like that it is sturdy as well. Thanks! Actually it only took a few hours. E.g. 1950 plates at 1 per second would only be 32 minutes. The hard part was getting the six rings aligned correctly - when only a few are present they do not hold together on their own... Share this post Link to post Share on other sites
