Alexgri Posted January 13, 2012 Hi guys, I need to use in my MLCad creations rubber tubes (can you tell me the correct name and lego id part too?) like this one: Thank you! Share this post Link to post Share on other sites
roland Posted January 13, 2012 I need to use in my MLCad creations rubber tubes You need to look into LSynth for that. Asking this on the LDraw.org forum might give you more insight though. Share this post Link to post Share on other sites
Alexgri Posted January 14, 2012 Thank you very much! I'll try this.. thanks! Share this post Link to post Share on other sites
Alasdair Ryan Posted January 14, 2012 (edited) You could pm the file to me (you will need to upload it via a filehosting site) and i could place the hose for you. Edited January 14, 2012 by Alasdair Ryan Share this post Link to post Share on other sites
Alexgri Posted January 15, 2012 I followed the instructions at http://www.holly-wood.it/lsynth/tutorial-en.html (not working now, no idea why) but the program doesn't not reveal the lsynth library! Tomorrow I will re-try, thanks! Share this post Link to post Share on other sites
roland Posted January 16, 2012 but the program doesn't not reveal the lsynth library! In the "Installing LSynth" section there are two more downloads besides the main setup. Did you install those too? Share this post Link to post Share on other sites
