ReplicaOfLife Posted October 29, 2017 (edited) I recently fulfilled one of my old childhood dreams and got the 6195 Neptune Discovery Lab from Aquazone - a set I've been drooling over for more than 22 years now... Anyway, when I was building it, I started wondering: How were those raised baseplates actually produced? Does anyone know that? Since the printing is continuous throughout, I would assume that they propably printed first and then pressed into their final form. I can't think of any other way that would allow for such a continuous print on a 3-dimensional surface. Thanks Edited October 29, 2017 by RogerSmith Share this post Link to post Share on other sites
JopieK Posted October 29, 2017 Probably they vacuum formed them. Share this post Link to post Share on other sites
