Alasdair Ryan

What about copying the gear box from the unimog?

No i don't need a kick up the bum but thanks for asking ,i hope to finish it this week and then i am going to ask Blakbird if he will help me with the cad file.If there is any one else out there that is good with mlcad of sr3d let me know.

Do i here the sound of pneumatics?

Some progress,i think i will make it a bit longer.

Is it just me or does it seem that Dluders has had a kick up the bum from someone?

Gearbox of some sort?

For those who would like a skip trailer or add-on for the moc how wide/long do you want it to be? And what bodys would you like for the skip? (sorry if you think i am taking over your post)

I will upload a pdf for you pat. Download pdf file

Nice snow cat.

I have finished the trailer,very sorry about the build order.(you need to open this file with mlcad) Download File

Nice truck.

Well shot me ,why can't people just use common sense a bit more,people who want to take part should make something that you can expect to find in the water, would hope that entrys that use water in a differant way other that a water craft of some sort will be weeded out.Obviously thay should be lee way for entrys but not too much.

Smaller? i dont know. If you keep the slew motor in the chassis you could have another function like teleboom or open close grab,also bare in mind that you will have wires going though the turntable that will twist if you go with motors mounted in the crane.

Ah thanks very much i think my project will be a lot harder than ether of your moc's.

Hay thats what i say.........no i say 'you clown' it's alright.

There are three function's if useing it like below (excluding the gear change),the motors would stay at the bottom in the chassis,or you could remove the upper part and be left with just two functions. That's quite all right. You got to learn from something. Yes the drive shaft and the second gear change if you want three functions.

^ | (look at the second post of this page) This set up could control 2 or 3 functions remotely.

Ok here is the best way: (the gears ready to go though a turntable) however if you need another function you should mount the gearing set up after the turntable and use one of the existing drive shafts for the gear change you should be able to to this with only one function,however this does take up room.

I allways liked that set,but i never did get it.

i will post a idea in a hour.

Can i interest any one in a tipping trailer? Its not quite finished.

I think you should have it flat on the chassis and just go though the turntable.

Nice job.

I am puting a reduction on when it goes to the diff (xl - 6th - 24 (diff) then the the axles.

Hang on an i will take a pic. Edit: I have tested it and it does turn.