efferman

Yes, please do it.

I have indeed a disc like this.

Ok, they were faster than me when this is correct.

The tires and the Cab are 1:20, the width is around 1:18

OK, there is a unicorn. My fault.

One suggestion, remove two of the pistons of the straight six. All of the Unimogs have 4 cylinder engines

The crane is much to large for this position. I think this looks totaly out of proportions. Made in IO an incomplete chassis with my portals based on the 42242 https://bricksafe.com/files/efferman/u5023/42242.io Next two of the straight six cylinders will removed. The U 5023 has only 4cylinder engines. The Steering link needs a different position.

The Rim is printed, because as i stated befor the 8Z doesnt fit to the original Rim. the rotation doesnt change with this setup, but the reduction makes a rear portal neccessary too. The part in the center is to connect, in a space saving way, the left and right side without the risk of dismantling under pressure.

24 teeths on the inner side of the rim. So the rim is like one of the old Turntables.

It jumps a bit on 35 Degrees, so it should a bit limited.

It works. Includes a 3:1 reduction

The Pickup is wonderfull.

The Steering Scrub Radius would be much to large for a model of this size. Edit: i think i have a solution. The first print runs

The Rim of the Set is much to small in diameter. Even 8/8 would not fit.

The L beam which supports the shocks does not limit the steering angle? Btw, the hub seems to work.