Hello guys,
I started working on a new project. It will be 1:10 sedan with power functions (two L motors and one M motor). As I don't have an access to bricks at the moment, I'm designing it in LDD.
My goals:
- rear multilink axle by Sheepo
- gearbox - not necessary, but it'd be nice to have it
- front axle - semi double wishbone with proper angles
- clutches, so the motors can be disengaged and car can be played manually too
- fake engine - due to design of front axle it's only I4
- chassis at the moment is also by Sheepo, but the front part of it will definitely be changed
Here is my question to you - does it look good? Will it work in real life? Focus on the front axle, rest can be rebuild later (I know I have to strengthen the gearbox). Are the angles ok? I have a problem with attaching top wishbone links properly. As you can see, I attached front ones without a problem, but the back ones give me a headache due to caster angle.
Could someone help me and point me the way how to do it?
Thank you in advance!