fred67 Posted August 23, 2010 (edited) I found this article on a technique for making more "realistic" tracks, but was wondering if the only way to get curves on base plates is to "float" them using tiles, and wondering if that's what most people do. With all do respect to Dave, too. Edited August 23, 2010 by fred67 Share this post Link to post Share on other sites
Chumley Posted August 23, 2010 (edited) I found this article on a technique for making more "realistic" tracks, but was wondering if the only way to get curves on base plates is to "float" them using tiles, and wondering if that's what most people do. With all do respect to Dave, too. if you don't mind the track raising for the curve you can just float it on studs, but it will raise your track by the height of the studs. here is a picture of the corner of my layout mark Edited August 23, 2010 by Chumley Share this post Link to post Share on other sites
peterab Posted August 24, 2010 I found this article on a technique for making more "realistic" tracks, but was wondering if the only way to get curves on base plates is to "float" them using tiles, and wondering if that's what most people do. With all do respect to Dave, too. I'm pretty sure on of the US LTCs had a diagram online of the studs that lined up under the curves, and where jumper plates and 2x2 turntables could be used to get greater connection, but I can't find it at the moment. The rest was mostly supported by tiles as in your examples though. Share this post Link to post Share on other sites
fred67 Posted August 24, 2010 Thanks for the replies. Share this post Link to post Share on other sites
jojo60 Posted August 24, 2010 Here is a usefull link : http://www.ngltc.org/train_depot/crvstuds.htm Share this post Link to post Share on other sites