Bending 12v crossing? (7857)

[cozzie4d]

Hi all,

I've noticed that my track cross (7857) bends down when a train drives over it. Unfortunately there are no 'stud connectors' at the bottom to make it stronger/funded.

Any best practices on fixing this?

[Andy Glascott]

I’m pretty sure a 1 wide plate will stick to the underside of the track along the length of the track, maybe try that? I can’t remember what the underside looks like but do remember the metal connectors are underneath so it might not be possible to run a couple of 1x8 plates the length of it…

I’ll have a look at mine later and see if there’s anything else I can think of.

Update Yes, I was able to put a 1x12 plate under the crossing, across the gap where the metal connections are, attached to the underside of the rail. 

Edited April 22 by Andy Glascott
Update

[cozzie4d]

Thanks, I didn’t know 1x12 existed :) if you have a picture that would be great

[Andy Glascott]

Here you go - https://flic.kr/p/2pLJC3U

[cozzie4d]

Ah that's a perfect solution, thanks. I'll get some 1x12's, ideally in light or dark grey.

Thanks again

[BillytheKid]

Just put some dark grey 2x2 like this :