Mattallica Posted September 17, 2020 i fixed the jawline, which is what i think makes it look weird, on mine by removing two pieces,and adding two different ones.then just moving some around. i think it looks much better what do you think? Share this post Link to post Share on other sites
JintaiZ Posted September 17, 2020 I think it looks a lot better. Share this post Link to post Share on other sites
do2 Posted September 18, 2020 Darn - that looks good! Now I had to buy one... Share this post Link to post Share on other sites
Pisces no Aphrodite Posted September 19, 2020 It looks better than the original. Share this post Link to post Share on other sites
Warbinator Posted October 10, 2020 Looks a lot better. The enlarged jowls is what has kept me from buying this set. What pieces did you remove and what pieces did you add to replace them? Share this post Link to post Share on other sites
Dragunov2 Posted October 10, 2020 Correct question ;) Share this post Link to post Share on other sites
Mattallica Posted October 11, 2020 (edited) ok so start at step 155 you swap the ball and socket positions, this allows the final assembly to lay flatter against the face the pieces eliminated are the two red 6186398 Slope, Curved 2 x 1 Inverted added are two 2x2 dark red tiles here are pics of the left side Edited October 11, 2020 by Mattallica Share this post Link to post Share on other sites
Warbinator Posted October 21, 2020 I like that a lot!! I might finally have to break down and buy this set. Share this post Link to post Share on other sites
