Marc Muller

question regarding connection between two parts in LDD

5 posts in this topic

hello

i am trying to connect an angle plate 1x2 1x4 and a technic brick 1x2 (with 2 holes) so that the technic brick is connected via the 2 holes to the 1x2 plate on the angle plate. LDD does not accept this....

connection.jpg

is there any way around to connect those?

many thanks

Marc

Share this post


Link to post
Share on other sites

No, I also tried that.

It seems that into these holes (on techinc brick) can only be applied axles, connectors and simmilar pieces.

Share this post


Link to post
Share on other sites

Well technically this is considered an illegal connection by TLG, because using more than one hole makes the clutch power to high.

This would mean that two 1x1 technic bricks should work, but it doesn't. :wacko:

The workaround is to put two 1x1 plates between the bracket and two 1x1 technic bricks. However that means putting an extra plate thickness between the bracket and the brick.

Oh, and Welcome to Eurobricks, Marc!

Share this post


Link to post
Share on other sites

Yups otherwise it will become an illegal connection (like Vincent posted while I was typing ;)). Sometimes very annoying, but not much we can do about it I'm afraid.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.