N-4K0

Darth Revan

Thanos and Nightwing.

Miles Morales Spider-Man and The Joker.

Chief Tarfful

Gray Squadron pilot.

Winter Soldier and Scarecrow.

Vader as a character in the movies has a bigger head due to the helmet. I feel that the molded helmet piece is a bit too small compared to the body. It looks to be of the same size as the other figures' heads, but should ideally be a bit bigger. Same issue goes for the Jango Fett figure, the head should IMO be a bit bigger. That said, I'm also curious about what's going to be new with the second Vader figure, as well as eager to see the Boba Fett figure although I don't expect it to be remarkably different from the Jango one.

Bith musician.

Doc Ock and Deadshot.

Ultron Prime and Scarecrow.

Astromech droid.

Hera Syndulla

Iron Fist and Green Arrow

In general, I personally would like the 2L black pins to be a little thicker and more solid cos whenever I want to make a rigid 2L thick connection, I find it necessary to use LBG frictionless pins together with them if I have less than like 5 studs for the connection. The frictionless pins adds more "hold" than the friction pins alone, I find.

Compared to the other red parts visible that are also on the underside and in the shadow, the central diff certainly looks red to me. Also, although it looks unusual and a bit strange, I'm starting to find the 42070 B-model not too bad.

TC-4

Ultron Sentry - Batzarro.

On a side-note regarding pins: I don't want to spin this thread off of topic, but I often feel like the same pins have different amount of friction and grip in different colored liftarms. For instance, a black or blue pin that sits well with good friction in a yellow liftarm often feels like it sits more poorly in a DBG or red liftarm and the other way around. I don't understand it.

On the subject of black 2L vs. blue 3L pins, I personally prefer to use blue 3L as I generally feel they have more friction and makes the connections I make, stronger. Like Erik Leppen mentioned in regards to MOCs, I find myself needing quite a lot of pins to get the sturdiness and friction I feel necessary when I make a bigger MOC.

Bring it on!

I can't but agree that it's hard to choose. Darth Vader with new helmet mold or Boba Fett with really well done printing. Oh well, I can't but vote for my favorite character of the two, Darth Vader.

Rocket Raccoon and Pirate Batman

Scorpion and Scarecrow.

Boba Fett vs. Darth Vader

Magneto and Joker.