Sign in to follow this  
Boernie

problem with, 3673 Technic

Recommended Posts

Hello everyone,

I have a little problem in the program Stud.io. The technic stone (Technic Flex Cable End Double, Pin Connection) can not connect to the (3673 Technic, Pin without Friction Ridges Lengthwise). What am I doing wrong? He can not be pushed on and always jump aside and if, then not completely up to the stop.

Share this post


Link to post
Share on other sites

I think that the Stud.io recognize it as an illegal connection. If you really want to connect that, you might want to turn off the collision detection and place it to the middle of it. As you can see that the part is not perfectly aligned, to fix that, you should move the part with the "fine grid" control until you feel it right to it's place...

Edited by KamalMYafi

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.