DHal

What a great way to build nice train from technique to build for the Duplo. Do you have any other files then the animation so that we can generate building steps? It is really time consuming to go back and forward to figure out where is going to be placed and so.

12:10 14:6 11:4 13:3 25:2 9:1 Hard to choose. Well done!

Good, they must use 69819, though. I should be for rotating the turntable.

At the bottom there are 4 axle-3 with stop. The claw's end connection cannot use any standard pin of size 3. It seems like there is a new 2x2x2 element there.

The center of the claw doesn't fit any technic item that I know. Do I missing something?

What a great simple RC design that have wonderful view. This clearly shows the point the Lego Technic is reached. The missing dark azure, somehow, makes the color more beautiful for me. Yes, a real-time video will be nice. It seems a challenge to built this design with power functions. Will you provide the instruction?

Great! Even almost all of the motors are invisible, I guess the tandem axle is no more working. What is the effect of two pneumatics instead of one on the winch?

The reverse was really fun for me. I had a three wheeled motorbike as in one of the 888x idea book. I was installed a 8700 motor to it, drove it back then immediately forward, hurrah, I had two wheeled motorbike. It could have gone like half a meter then drop the front wheel. It was my ultimate fun those days.

Great initiative. I've used with on Redmi note 8 on the old gen receiver Here my problems; 1. I cannot change the channel. 2. Train mode doesn't work on motors. Here my considerations; 1. Can we use more than one channel so that an interface can control more than one receiver? 2. Is it possible to control the third party receivers, too?.

OK. I've built the set ( not fully though ), the gear 24 tooth clutch works fine.

Sorry, the main missing part is the new clutch. I've the drum. @Anio and @astyanax , Instead of the new clutch I'm using the old one. @Gumalca that is a good point, however, they have different construction that we can't replace them directly. There is a gear 24 on the path from drum to drive that I can replace it with the old one.

How I can really compare that if I don't have the new clutch? It seems working. Then What is the rationale behind using the new cultch here?

I'm trying to build the 42112 cement truck from my parts. It uses a new clutch, I didn't have one and I did not want to buy either. Instead of the instructions I went into this way Instead of the Gear 24, I've used gear 24 tooth clutch. I don't see that this design lack of any property of the original. Am I missing something?