platinum831

moved to discord

i have changed the position of the sway bar to a more inward approach but should i be connecting it to the knuckle instead of lower control arm as it just moves the arm and doesn't cycle the suspension

thanks fixed

hello i am working on a moc with multi link suspension it will have pneumatic cylinders as the shocks to act as air ride the steering of the suspension is a little funky and I don't know where i should mount the cylinders too in order to get full suspension travel with them installed any help is greatly appreciated

check the diffs you may have the ring gear on the same side for both one side needs to be opposite of the other one

so i got the basis of what i wanted to build i still need to add in a locking center diff and figure out how to add another speed gear ration on

so far i have a frame and axles for a truck i am building i would like to put a transmission in this truck with both front and rear drive and also dual pto one to front and one to rear as i will be running a winch in front and just a normal pto out put in the rear there are some measurements on the screen of what i have now it can be widened i just don't know how to build transmissions and would like some help

it will be fully on air and there will be a strut bar at some point to support and not let the upper mount deflect in still in the beginning stages have no actual chassis built yet alot of the 64179 pieces are there just for holding it together for now if you have any suggestions let me know

i have redone the front knuckles (not exactly how i want them but will work for now want more slimmed down look) brought the wheel base in a lot lower sub-frame is next with new mount for control arms steering and sway bar plus i want to make this moc all wheel drive with rear wheel drive only selector so i need to make a mount for front limited slip diff would like some help on how i should go about building the sub-frame i have an idea but don't know if its going to work correctly currently tried using nicjasno's e30 style lowers but will need to modify to work properly also used the way he mounted his pneumatic cylinders as a base for mounting mine

hello thanks for the info yes it will got slimmed down in the front and the rear will match width this is just proof of concept and i will be redoing the knuckles and thoses wheels will not be the ones i am useing

i am currently starting to work on a car moc with McPherson strut front and multi link rear suspension i have a front mock-up done but i think i am going to be changing the knuckles around would like some pointers on chassis building and seeing images of your multi link suspension setups

sorry to bump an old thread but i would really like to know how the full front suspension was made on the e30 knuckles and all i am trying to build a macpherson front suspension and multi link rear moc on pneumatic air and would like some pointers@nicjasno