Help needed with fitting hubcap in wheel rim 56904 (30.4 mm)

[slam23]

Hi all,

I'm building a car with wheel rim 56904. It's attached with an axle. Now I'm looking to fit the rim with a nice hubcap, and I have chosen a 3x3 (satellite) dish. But I can't figure out how to attach the cap (dish) to the wheel rim? I found a part (424) that seems to go into the wider hole around the axle, and it reverse fits a stud, but I then can't continue with fixing the dish to it. Any help? Much appreciated!!

[Stereo]

I'm not sure about part 424, but the normal Lego way (sets like the Icons/Creator Expert cars) is 1x1 round plates - 6141 or 85861.  You could check 10290's instructions as it uses the 3x3 dish.

Edited August 8, 2025 by Stereo

[slam23]

Thanks @Stereo! I just tried to fit 1x1 in the hole of the rim, and although Studio 2.0 does not think there is clutch power, it seems to fit the whole hole. I'll go with this solution for now I think, I'll need to get some real bricks in house to fiddle around!