RC Tracked Snowplow

[bruh]

Hey everyone!

Today I present to you: My RC tracked snowplow!

For propulsion, I used 1 Spike Prime M-Motor to drive each tread with a 1.67:1 gear ratio.

This enables it to make a perfect zero point turn. The two Control+ M-Motors seen above control the lifting and angling of the plow blade via two large linear actuators.

The plow is easily removed by pulling the red 6L axle out of the front teal axle-pin connectors in the center of the plow and disconnecting the 5L black liftarm connected to the linear actuator that controls the blade angle.

The hub is accessible by lifting the roof, and the blade can be easily stored inside the vehicle:

Here are photos of the code and control panel:

I did not make instructions for this, BUT I am planning on making a similar vehicle: a tracked RC offroader. Although it will be similar, there will be some major differences and upgrades. I DO plan to make instructions for that.

[Thirdwigg]

Good job on the coding, and thanks for sharing this MOC with us. I hope you are able to create and share more here.

[bruh]

Thanks! Right back at you!