[WIP] Rebel Tracked Racer

[Ctan]

Hi, after building previous crawler for TC17 I left with lot of unused parts... So, I decieded to use them in other creation.

A lot of weight and size compromises have been made. For example 3 buggy motors instead of 4.

I have started sketching the bodywork.

engine is now without shaft but there will be one and also chain linked to the middle 5292 buggy motor

Tracks goes very smooth, even front tracks are working properly and doesn't disconnect from differential. Hooray. Front suspension is a bit wobbly but when driving it's not visible.

@Zerobricks you have a lot of experience with buggy motors and BuWizz and maybe I do something wrong.
I have connected 2 back motors to one buwizz, 1 middle motor and servo to second BuWizz. I can drive only on slow or normal mode without overloading it. On fast it almost instantly stop and disconnect. Is this normal behavior? Thanks in advance for any help

 

 

[Zerobricks]

9 hours ago, Ctan said:

@Zerobricks you have a lot of experience with buggy motors and BuWizz and maybe I do something wrong.
I have connected 2 back motors to one buwizz, 1 middle motor and servo to second BuWizz. I can drive only on slow or normal mode without overloading it. On fast it almost instantly stop and disconnect. Is this normal behavior? Thanks in advance for any help

 

 

Yes, that's normal, RC motors are very power hungry, especially from a standstill. Try switching to fast and ludicrous mode after gaining some speed.