Once again, I just couldn't be more pleased with this year's Speed Champion sets. As some of you will recall, I've been widening the standard Speed Champion cars to be 8 studs wide. I just prefer the aesthetic, and now my drivers aren't centered in what is supposed to be a 2 or 4 seat car. 2016 cars http://www.eurobrick...opic=122188&hl= 2015 cars http://www.eurobrick...36#entry2154620 The Model A was a special case because while it surely wasn't the scale that would necessitate 8-stud width, I didn't think it needed to be 6 studs either, so I went with 5, which keeps it a small old hot rod size, but is still more to scale than the tiny 4-stud configuration that comes with the set. In addition to the change in width, I've done a lot of detail work, from the engine to the back of the car. I didn't change much on the Raptor but did add to the garage pit area. This was so much fun I immediately began building more hot rods in this style and scale. Edit: Here's a link to the other hot rods. http://www.eurobricks.com/forum/index.php?showtopic=134719 Enjoy! For comparison, here is the stock version: