Problem with different-sized wheels

[dren0ma]

im having a wheel problem with my current MOC. im using a 43x26 balloon wheels, and the smaller 37x18. what is the best way to attach them to beams so that both of them are on the ground? i want to keep the frame in a straight line and i dont want it to slant towards the back/front.

Edited May 4, 2013 by dren0ma

[nikolyakov]

[legomuppet9]

^^ Your answer ^^ no other way of doing it

[dren0ma]

are there half-stud beams? the height difference is only around 1.5 plate when placed on the same level beam, so i left it "lowered" at the back for the meantime.

[legomuppet9]

Well then you have no other choice but to have it slanted

[DLuders]

@ dren0ma: You may be able to use the 2853 "Technic Engine Crankshaft" to get your 1/2-stud offset:

[Tech-nick]

And:

1,5 offset

[branolego]

I believe you can also get a half beam offset by using the angle beams. You would just have some of the beam either sticking up or down.

[Boxerlego]

You can stack this part with another one on a axle with a 1/2 bushing in-between to get a 1/2 stud offset.

[Junpei]

Use these: http://www.bricklink.com/catalogItem.asp?P=6575