legosubmarine Posted February 25, 2013 Posted February 25, 2013 Hi ! I'm looking for the way to put a wire from a sensor to the nxt brick, and I didn't find any explanation anywhere. LDD is a 3D tool, but I really don't get how to put a piece "higher" ("z axis") ?? Could you help me ? Thanks a lot ! LS. Quote
Alasdair Ryan Posted February 25, 2013 Posted February 25, 2013 (edited) Hello and welcome to Eurobricks. In LDD you can only add the ''ends of the cables'' If you require software that will join the two ends together by adding cable you will need to use different software. The main program that will do what your looking for is called LSynth and works with MLcad. It can be quite tricky to get the hang off at the start but it will get easer to use. Edited February 26, 2013 by Alasdair Ryan Quote
legosubmarine Posted February 25, 2013 Author Posted February 25, 2013 Thanks for your answer ! :) Is there any way to move pieces up and down, following the z axis ? Thanks ! Quote
dvsntt Posted February 25, 2013 Posted February 25, 2013 Place bricks Ina stack. Put your piece on top, then remove the stack. Kind of hokey, but that is how I do it. Quote
legosubmarine Posted February 26, 2013 Author Posted February 26, 2013 Thanks for this answer ! Quote
Superkalle Posted February 26, 2013 Posted February 26, 2013 OT: Is that Galois in your Avatar? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.