Would a 99010 fit inside of the toothed hole of a 4845?2cx1?

[SNIPE]

Hi,

Would a 99010 (both halves of it) fit inside the hole of the grey part of a 4845?2cx1?

The 4845?2cx1 can be taken apart by sliding something thin inside of it and levering it open.

I noticed that when split in half a 24 tooth gear can fit in and it can be closed up again with a turntable inside of a turntable there is several degrees of freedom, also the small turntable has space for an axle through the middle.

[DLuders]

I looked on this TechnicBRICKS article about "Details about the new Mini Turntable". You are asking whether the complete 99099 + 99010 Mini Technic Turntable will fit inside the 48452cx1 "Technic Turntable Large Type 2, Complete Assembly with Black Outside Gear Section":

I went downstairs to check the fit with real parts, and NO they don't fit. The straight 3L Liftarm portions of the Mini Turntable cannot pass into the larger Turntable's central hole. Even if it did, the Mini Turntable's straight Liftarm portions could not rotate very far without hitting the larger Turntable's straight Liftarms.

[SNIPE]

The grey part is take off the black part of the large turntable so the liftarm part of the black part.

Here is an image that explains it a bit better, the flared grey bit is where the small black part goes in , from that side, the liftarms are on

The small turntable may need to be disassembled to get it in, its ok if one half of the lift arm does not spin as the other half will.

the grey large part does not have the black part put back on.

[DLuders]

I don't understand what you mean. Can you arrange the following images in order, so show what part goes on which side? Right-click on each image and look at the "Properties" to get the image URLs, the "Insert Image" in your reply.

Edited July 7, 2012 by DLuders

[SNIPE]

The small black bit should fit inside of the large grey bit but on the flanged side of the large grey bit. then you put the other half of the small bit on, the large black bit is not put back on.

Edited July 7, 2012 by SNIPE

[DLuders]

The small black bit should fit inside of the large grey bit but on the flanged side of the large grey bit. then you put the other half of the small bit on.

YOU WANT TO GO INSIDE

I tried doing this with real parts just now, and pried the large Technic Turntable apart with the dull side of a butterknife. It does not work. The Mini Turntable's 99010 black gear cannot be inserted into either side of the large gray portion of the 48452cx1 Technic Turntable.

[SNIPE]

Hmm how many teeth does the small turntable have.

[DLuders]

I just counted 28 teeth on the black portion of the Mini Turntable, and 24 teeth on the Light Bluish Gray part of the large Technic Turntable. Therein lies the problem -- the diameter of the small black Mini Turntable is LARGER than the diameter of the interior gear of the large Technic Turntable.