Help connecting two girder struts

[SNIPE]

Hi,

I might have to rescale the outside bricks as there is SNOT building so they are studded on the front and back, the clutches are on the inside on both sides.

When I try to join them together there is a 0.6L gap so it is too wide for a 0.5L bush or 1L bush.

I don't want pins or axles put in the holes lopsided either as it will mean that the beams are too long and will force the structure apart which will look 'bad'.

The parts I want to join are the blue parts.

Here is the LDD file:

http://www.brickshel...ridge_large.lxf

Edited May 7, 2012 by SNIPE

[88high]

You can modify a bush long enough for your needs by taking a 8t gear and a razor blade, cutting off each tooth, and then put a axle through it, and cut a bush your desired legnh out of your 1-stud wide area. Good luck!

[SNIPE]

You can modify a bush long enough for your needs by taking a 8t gear and a razor blade, cutting off each tooth, and then put a axle through it, and cut a bush your desired lengh out of your 1-stud wide area. Good luck!

Ah sorry I'm not into cutting or gluing Lego I think Ill just rescale the outside part, since its SNOT I have to make it big enough so one brick equals so many bricks which are put sideways