wishbone ideas?

[SNIPE]

Hi, im in a real pickle.

The model is a torsen differential that works by spinning round a set of 4 worms gears which spin another spur gear meshed onto that, at split second points the gear is totally unmeshed because lego dont make a larger torsen gear and even if they did the worm gears in my model slip against each other by rotating to a point where only the other one has to rotate for the prior one to spin a little more. and so on until there is a recycle of the original worm gear Id like to have wishbones and working suspention , the suspention Here I'd like to be able to have this differential to be part of a x928cx1 suspention box connected to the hole that pivots the wishbones (the hole of the box is the one that rotates wlong with the internal spring) and id like to use the CV joints, the 57515 wishbones and the x873cx1 spindle so the car as steering.

Here is the building guide to the torsen diff, the LXF file keeps on deleting parts when you open the file so I cant upload that.

Edited January 11, 2012 by SNIPE

[Alasdair Ryan]

If its a cad you are wanting you will need to wait tomorrow as i do not have ldd on this computer.

[SNIPE]

If its a cad you are wanting you will need to wait tomorrow as i do not have ldd on this computer.

ok A.

[Alasdair Ryan]

I found this design:

Web Page link

[SNIPE]

Man ive beek looking for a part that is 2x2 holes but with a center hole so thanks for showing me the gears in the above diff you posted

I still think my diff is better becuse of the limited slip between each worm gear mesh, it is putting it into a model with the above key parts listed that im stuck with.

Edited January 11, 2012 by SNIPE

[DLuders]

@ SNIPE: Have you seen the various Torsen Differential designs on this TechnicBRICKS article?

[Alasdair Ryan]

I have made this below i hope it was what you were looking for,i could not see the LDD file.