round brick 1x1x3

[SNIPE]

hi, is there such thing as any of the below parts but with a cross hole bit in the underside, i seem to recall me using some but after getting 5 out of the box there seems to be smooth undersides:

http://www.bricklink...m.asp?P=3062old

http://www.bricklink...tem.asp?P=3062b

http://www.bricklink...tem.asp?P=3062a

http://www.bricklink...sp?P=3062oldpx1

http://www.bricklink...asp?P=3062bpb37

http://www.bricklink...asp?P=3062bpb36

http://www.bricklink...asp?P=3062bpb35

http://www.bricklink...asp?P=3062bpb01

http://www.bricklink...asp?P=6933cpb01

http://www.bricklink...asp?P=6933cpb02

http://www.bricklink...tem.asp?P=6933c

if there is not any like that with a cross hole, do any of the above have a cross hole.

note that the whole part of the hole is not crossed, ,its like that so far down so the first area is round and then it would go to crosses when you go further into the underside clutch.

Edited July 31, 2011 by SNIPE

[Captain Green Hair]

As far as I know, only the 1x1x1 cone piece comes with a cross hole.

[SNIPE]

hmm that wont help because there is a tire that goes over the brick (that brick will be the rim of the wheel assembly) so a cone will not be good

i should be fine now after finding more.parts to create a new assembly that could work

Edited August 1, 2011 by SNIPE

[davee123]

If there's a wheel around it, then you could use 2 technic half-bushings (or one half-bushing and a 1x1 round plate if you need the stud on the end). Or (depending on your setup) you could use the 3-long axle with end-stud, and attach the 1x1 round to the end.

DaveE

[SNIPE]

can you post an image of the 1x1 round plate thanks

i could also use a 4L axlle with stop or a threaded 4L axle and have nuts on either side of the rim

Edited August 1, 2011 by SNIPE