how does the RD buggy wishbone and spindle attach?

[SNIPE]

hi, in this picture http://www.bricklink.com/catalogItem.asp?P=techstr04

i see the two parts together but i don't know how they are attached, it looks like there is a attachment hole in the top adn bottom of each part so does an axle or pin need to be put in there?

i want to put either this

http://www.bricklink.com/catalogItem.asp?P=6628

or this

http://www.bricklink.com/catalogItem.asp?P=2736

in the top and bottom holes of this http://www.bricklink.com/catalogItem.asp?P=techstr02 so that i can mount these

http://www.bricklink.com/catalogItem.asp?P=57515

Edited May 7, 2011 by SNIPE

[allanp]

Sorry, but there are no top and bottom holes. In this picture you can see a bulge on the top.

http://www.bricklink.com/catalogItem.asp?P=techstr02

There is another bulge on the bottom. These bulges clip into the other piece holding it in place.

[DLuders]

So, you want to find out how this piece is all connected to the chassis:

You want to put either of these two pieces

...in the top and bottom holes of

...so you can mount these?

I looked on this Bricklink page to see what sets the techstr02 parts were used in, then looked at the inventories for those three sets. A few of those Technic pins that you want to use are shown.

The 8475 RC Race Buggy is a good example. On Brickfactory.info , I looked at the individual pages of the Building Instructions to see how the techstr02 parts are connected to the chassis. On Pages 18-19, one can see that the two parts of the techstr04 assembly click together and are held onto the chassis with a Technic Axle and Technic suspension Links:

[SNIPE]

in that case i better stick with using the spindle inner part and using the 4L universal joint (if it works)

(post for that is here http://www.eurobricks.com/forum/index.php?showtopic=54506&st=15&gopid=983735entry983735

and here http://www.eurobricks.com/forum/index.php?showtopic=54506&st=0&p=974017&hl=SNIPE&fromsearch=1entry974017)

Edited May 7, 2011 by SNIPE