Ideas for an arched lattice window

[Jack Sassy]

Greetings!

 

Lately I have been testing some arched lattice window designs as one is required for a project. The official 1x2 design is too small, but a 1x3 wide design would be perfect. While researching, I found the best lattice part to be this 1x4 fence piece. After a few failed ones, this is the best design I have come up with:

However, this design is not completely perfect: while formwise the mudguard piece fits perfectly, it does cover the upper part of the window from the inside. I do not own any 3mm pneumatic tubes, nor do I know how to work with them in Stud.io. Perhaps those could be a good answer, or not. What do others think of this, perhaps someone can come up with a better solution? I would much appreciate some ideas or even other designs.

 

All the best,

Jack Sassy

[Yoggington]

Have you considered the older lattice window piece? i.e. Pane for Window 1x2x3 Lattice

I'm afraid I don't have any at my current location, so I can't verify 'in the brick', but if I recall you can wedge these between the groove of a rail piece and the underside of an arch to some success.

Studio mock-up:

edit: I got so excited with my idea I didn't read your 1x3 width requirement. I'll leave it there for future browsers.