spidercircus Posted February 7, 2021 Posted February 7, 2021 Hi all, I'm trying to finish up a moc where the large solid wheel (54mm) part# 2515 is part of the engine, with a 6x6 dish fitting inside it. It works in stud.io, but when I try to put it together the dish won't fit inside the wheel. Any ideas if I'm just missing something obvious, or if there's a better way to do this? Quote
deraven Posted February 7, 2021 Posted February 7, 2021 (edited) That is odd. I think there's an issue with the parts in Studio or maybe the collision detection. I can confirm that they definitely don't fit IRL, but in the program if i repeatedly try to make them fit together making fine adjustments Collision Detection will sometimes toggle itself off on its own. Then if I turn it back on it appears the parts fit until I fully move them apart, but then I can't put them back again unless CD is turned off. It's odd. Edited February 7, 2021 by deraven Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.