servo motor question.

[Mechbuilds]

If the servo motor can't turn the whole 90 degrees, will it break if i force and hold it in say.. 45 degrees instead? 

[AndyCW]

The servo will just stall.   There are videos on YouTube demonstrating the servo's characteristics

[allanp]

It won't break it but another solution, if you have room for it, is to gear it down 2:1

[Mechbuilds]

4 hours ago, allanp said:

It won't break it but another solution, if you have room for it, is to gear it down 2:1

So it's adviced to gear it down properly if possible.. I think i'll use effermans lever solution to get the excess slack of the 90 degree turn. 

[kbalage]

If you use BuWizz or SBrick for control you can limit the angle with the application

[Clawp]

4 hours ago, kbalage said:

If you use BuWizz or SBrick for control you can limit the angle with the application

Its possible from buwizz app ? or the new beta version?

[kbalage]

1 minute ago, Clawp said:

Its possible from buwizz app ? or the new beta version?

I checked it is not available in the BuWizz app yet (or at least I did not find it), but you can use BrickController 2 and limit the motor output % with BuWizz as well.