crayondrifter Posted July 5, 2018 Posted July 5, 2018 Ok, so one of my large motors works fine in motor control mode, when you press the button to run it, but when you run any program involving it, 90% of the time it will run at like 3 speed while the other Large Motor works fine. Any way to fix this, or is it a bad motor? Quote
mocbuild101 Posted July 5, 2018 Posted July 5, 2018 1 hour ago, crayondrifter said: like 3 speed ? Quote
crayondrifter Posted July 5, 2018 Author Posted July 5, 2018 Sorry, what I meant to say by 3 speed was that the motor only runs at 3% power, going extremely slow while the other motor works fine. Quote
mocbuild101 Posted July 6, 2018 Posted July 6, 2018 Hmm, that does sound strange... Maybe try all the different ways to control it and see what happens (connect the motor to port D to make sure you don't need to switch ports): Motor control mode IR control mode Brick program Computer program (normal motor block) Computer program (unregulated motor block) Quote
kieran Posted July 8, 2018 Posted July 8, 2018 Test on each port and swop motors ove to make sure it's not a bad cable and or port Quote
crayondrifter Posted July 8, 2018 Author Posted July 8, 2018 Well, contacted TLG and they are sending me a new one :) Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.