SBrick Watchdog

[Lok24]

Hi all,

got some trouble with my SBrick Hw 5.0 / FW 5.1.

Writing the watchdog time with 0Dxx and reading it with 0E works, but there is no effect.

Setting it to FF should give time of 25,5 sec, setting it to 0 should turn it off.

But after program stops motor is stopped after less than 1 sec.

Does anybody know why that doesn't work?

Is there a description for the FW 51.?

Any help is welcome!

 

Edited February 13, 2018 by Lok24

[mocbuild101]

Er... maybe the SBrick forum would be more helpful: https://social.sbrick.com

Edited February 13, 2018 by mocbuild101

[imurvai]

15 hours ago, Lok24 said:

But after program stops motor is stopped after less than 1 sec.

Hi, Isn't it possible that the "program" disconnects after stopping? What program is it anyway?

[Lok24]

Hi,

Thanks.

@mocbuild101 : No Replies at all from Sbrick, the forum is not structured at all.

@imurvai : SBrick has no "disconnect" command. The "Program" is only one Command: drive! Same is when loosing the BT connection.

 

[imurvai]

8 hours ago, Lok24 said:

@imurvai : SBrick has no "disconnect" command. The "Program" is only one Command: drive! Same is when loosing the BT connection.

I meant what software were you using to send the drive command?

[Lok24]

Hi,

sorry for missunderstanding.

It's a little Python-script running on a raspberry-Pi .

Watchdog can be set and setting verified according to SBrick Protocol 17, but shows no effect.

Maybe there is a more actual description?

 

Edited February 13, 2018 by Lok24