wip 4ws supercar chassis pf 1:8th- 1:10th scale

[Aventador2004]

before i build my battlebot i decided to make a special project,

namely: a 4ws supercar with suspension and drive to rear axles

the steering works great 

Now uses gear rack in rear

Servo rear geared down 300%

Motors have a 3:1 gear ratio

New version updated

full gallery at http://bricksafe.com/pages/aventador2014/4ws# 

hope this will be usefull for all

Aventador

Edited March 18, 2017 by Aventador2004

[Didumos69]

You would gain a lot of points if you would finally link your images in instead of uploading them here. It has been explained before, but here we go again: Open a bricksafe image in your browser, for instance the 800x600 version. Copy the link from the address bar in your browser into your post while you're editing it. The link will be transformed into an embedded image automatically.

Edited March 18, 2017 by Didumos69

[Aventador2004]

6 hours ago, Didumos69 said:

You would gain a lot of points if you would finally link your images in instead of uploading them here. It has been explained before, but here we go again: Open a bricksafe image in your browser, for instance the 800x600 version. Copy the link from the address bar in your browser into your post while you're editing it. The link will be transformed into an embedded image automatically.

Ok got it now

 

[Matty04]

great start! will you build a bodywork from a specific car?

[Aventador2004]

2 hours ago, Matty04 said:

great start! will you build a bodywork from a specific car?

This was only a prototype

Not specifically a car yet but if possible it may be a gt3 rs without a gearbox

  A wip pic of a better new chassis will come soon, done

Edited March 18, 2017 by Aventador2004

[Aventador2004]

change of plans, for now the car is only a design study, it may soon be completed after some time

sorry 

aventador