Yeah, at €100, I might have to get me one of them when the time comes. Or wait until there's a discount.
Just spotted another thing: I think that the material handler is designed to be motorised with the 8293 PF set. Check out the pole reverser in this shot:
Edit: I also just spotted in the above, where the grey & beige bevel gears are in the claw, this piece in light grey?
Edit 2: And another one: On either side of that piece, and connecting the two yellow 5L half beams on either side of the 11L beam in the arm/boom/jib/whatever in this shot
, do I see some of these
3/4 pins in beige? A frictionless version, perhaps?
Finally, I'm not sure what's going on with the axle through the beige single bevel gear in the claw. It appears to be red (or possibly orange?), but if it's only 2L, I don't see how it can attach to anything on the other side. Unless it's fixed so it can't turn, and using that function swings the claw, rather than closing it, but that seems unlikely. A new part perhaps? Perhaps a shorter one of these?
Edit again: Whoops, it's just a mini linear actuator. My bad, I haven't got any of them yet, so I'm not very familiar with them.
Edited by Hopey, 01 December 2012 - 01:37 AM.