bd5400

Thanks but I think the hood is fine (unless I'm not understanding what you're referring to). It looks like I pushed in the front area while I was handling it/holding it upside down while trying to figure out the suspension issue. That caused the outer-most beam to angle up a bit, making everything appear out of alignment. I haven't changed anything, but it looks fine now, so I must have pushed it back after taking the picture.

Yes. Yes it should. I've been staring at this thing for what feels like hours and I completely missed that detail. I made the same mistake on both sides. Thank you!!!

I just completed my build of this set and I'm having a suspension issue that I can't wrap my head around. The suspension is way too soft and the rear of the car sits all the way down with the body resting on the wheels. I've gone over the instructions again, looked at comparison pictures, and I cannot figure out what could be wrong. Is it possible my suspension pieces are defective? I looked around online and I came across a single comment where someone had the same issue but no further information. Any ideas of what could be going on? Any help would be greatly appreciated! Edit: To clarify, everything feels like it is working, it's just that the suspension is too soft. The rear wheels feel springy and if you are holding it in the air and pushing the wheels up and down you wouldn't know something was wrong. It's only when you place it down does the weight of the vehicle make the entire rear sink. Also, please excuse my terrible job at sticker placement! Pics: