Hello again! This was back in the small picture of the project along, the last update is mostly gone backwards. because the front frame structure turned out too frail and had to make it new, it does not bear the crane torque. Now it begins to be strong enough but it is still not yet completed, among others, it is still missing the front end of the use of the lock cylinder and the turning of the crane as well as any design. But it is after all something a little more lived were available, the crane is Sånt two inner self in a follow-up, even when receiving the outer tube and mechanics to work so that both nested extensions should be evenly spread out, and also goes back in, remote controlled manner, of course. when the top of a crane outlined in the hull measured the interest in the whole length of the device, provisionally, and it is 120cm, I think that it is at least large enough for the machine.