Search the Community
Showing results for tags 'troubleshoot'.
Found 1 result
-
So I have a little problem and would like an opinion of someone more knowledgeable in this area. First I have to stress, that I know that all I did was my responsibility and only I am to blame for any damages. I have tried to make an PoweredUp to PF adapter using a SATA data cable. I tried to run some train motors, but it did not work. Maybe I used wrong wires from the SATA cable. I finished my tests and turned off the hub normally. A few days later, I tried to switch on the hub, but the led is not blinking and it does not show up in bluetooth. The batteries are charged and fine with a voltage of 7.6V . Is it possible it got bricked with some short? Is here a way to unbrick it? I saw a lot of good work from the community here, so maybe someone can answer my questions. I just want to find out if it is a lost cause. It would be a pity, because I managed to buy it on BL before the price hike. PS: I put this in the train forum as there are a lot PU threads
