Search the Community
Showing results for tags 'telescopic handler'.
Found 1 result
Good day. For a long time I wanted to create a moc with various functions apart from steering and drive. Overview: -4x4 drive with 2 diffs -3 steering modes : rear only, crab and all-wheel steering -Boom ascention -Boom extention -Forks tilting -part count of approximately 1000 pieces The forks on the end of the boom were able to be replaced with another attachment by pulling out two 8l axles with stop. The cabin has on openable door , adjustable seat and a lever to switch steering modes. The steering is a very basic type, the front stering motor is attached to a switch , which neutralizes it's movement or decides the direction of steering. the boom is extended through a pulley system , which was done due to lack of 4 stud gearracks. total boom size being fully extended is of 60 studs. The video below shows basic functionality. Something I learned with this build is that I should stick with smaller size mocs and not to rush into medium sized model. All photos here