Search the Community
Showing results for tags 'flight simulator'.
Found 2 results
This is my own design gbc. concept is fixed crank. V1 version Have only 1 plane. So slow. And V2 This is not finish yet. Need make ball suply mechanisem. But, this version have 2 plane so 2x speed than v1. Anyone have tip for ball suply mechanisem?
I present my new MOC, MOD Mercedes Arocs SILENT EAGLE Flight Simulator. Model was built for a competition on LUGPol.pl (polish AFOL forum). It is a flight simulator that can sometimes be found in amusement parks or at various air shows. But it is not based on any particular model. The original chassis is extended by a few studs between the axles to accommodate an additional pump in the compressor and gear drive for a second pair of outriggers behind the rear axle. Behind the Arocs cabin I installed servo and Ir to a control model . Everything above the chassis is already my design. It is full motion flight simulation platform with 6 small pneumatic cylinders each individually connected to a switch. The simulator is manually controlled from the cab. It is powered from its own compressor, two small pumps, airtank and PF XL motor. Additionally simulator is equipped with a new narrow long cylinder to open the door. It also has LED imitating projector and white panel acting as a screen. Two independent pneumatic systems are there to support vehicle outriggers does not lose pressure while playing simulator . LEDs are also in front and rear lights and running automatically when motion model. Weight 3.9 kg Length 61 cm Width 17 cm Height 24 cm 2 x PF L motor propulsion 1 x PF servo steering 1 x PF L motor mechanical functions 1 x PF XL motor simulator compressor 3 x PF swiches 4 x PF Led 6 meters of pneumatic hoses Gallery http://www.brickshelf.com/cgi-bin/gallery.cgi?f=559347 Movie