Hi guys ,
With some free time on my hands I started the digital version of my railway station in stud.io . When the main building was ready I tried to add some 12v track to the scene and ran into an issue.
The straight 12v track were just fine. A little hassle to get them built , but ok . Then tried to add some curved tracks. These were very much more of a hassle ...
There seems to be an issue with the radius or the length of the curved rail pieces. When I build 4 sections, I do not get the 90 degrees angle I expect. , see pictures below. It seems to be off by 3 degrees (counting studs and trigoniometry....)
This is also the reason I can not get the curved conductor rail into place. as it's radius is different fthen the outer track rails
I couldn't find a lot about this issue on the stud.io forum.... Has anyone else run into this and found a workaround ?