Jump to content
Eurobricks Forums

Recommended Posts

Posted (edited)

]I need help with a modified imperial Flagship i'm working on.

How do i attach the bow pieces at the front in LDD. I dont seem to be able to place them where they should be..

post-17837-0-25379500-1392923535_thumb.jpg

This picture should show better which part im on about

Edited by CaptMc
Posted

Hi there,

it's a bit tricky and you'll have to 'cheat' a little, but it's possible.

Here's my approach.

First you place a regular 1x1 round plate on the one stud, that the SNOT structure is supposed to be based on, place that grey piece on it, and use the hinge tool (in my case -130°).

1.jpg

Then place the first row of curved slopes, a connecting plate, remove the grey piece (and the round plate), and mark the following pieces.

2.jpg

Make them slide down along that bar, just to place the curved slopes closest to the prefab hull.

3.jpg

Last step is to place the rest of the SNOT structure, and clean up.

4.jpg

If you feel it necessary, use a bar to connect the structure to the prefab hull.

Hope this helps.

Regards

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...